Ford Flip Remote Key
Transponder chip programming for Ford and Lincoln vehicles can be done at home in an easy procedure if you already have at least two keys that are already programmed to the car.
Programming of The Chip Portion
Add A Key Using Two Programmed Keys (1min)
1) With 1st programmed key, switch the ignition to the ON position, one turn before starting the car.
2) Leave ON until the security light goes off, should take 5sec.
3)Turn the key to the OFF position and remove key.
4) Repeat steps 1-3 with a 2nd programmed key.
5) Insert the unprogrammed key and switch the ignition to the ON position. The security light should go off within 5sec. At this point the key is programmed to your car and you'll be able to start your car.
Programming of The Keyless Entry Portion (If keyless entry didn't program in the previous step, follow this procedure)
1) Within 10sec, cycle the key in the ignition On/Off for (8) times. A beep/chime will sound.
2) You are now in keyless entry programming mode.
3) Press Lock or Unlock on each remote (even previously programmed fobs). The door lock should cycle once, confirming the remote was accepted. If the door lock cycle twice or doesn't cycle at all, remote was not accepted. Repeat process.
4) Turn the car to the OFF position to exit programming mode and test the remote.
5) If the procedure failed, start the car on for a few second, turn it back off, and repeat the above steps.
Smart Proximity Key (Push Button Start)
Method #1: Add a Key Procedure (1min)
1) Place a working key inside the car. Within 10sec, press the start button (8) times. A beep/chime will sound.
2) You are now in key programming mode.
3) Within 10sec, press Lock or Unlock on each new remote. The door lock should cycle once, confirming the remote was accepted. If the door lock cycle twice or doesn't cycle at all, remote was not accepted. Repeat process.
4) your remotes are now programmed, verify your remote can start your car.
Smart Proximity Key (Push Button Start)
Method #2: Add a Key Procedure (2min)
1) Place 1st working key in the programming slot (look for a pocket either in the center console, glove box or under the cup holder mat), and press the start button once.
2) Wait 5sec, and press the Start button once.
3) Place 2st working key in the programming slot, and press the start button once.
4) Wait 5sec, and press the Start button once.
5) Place the unprogrammed key in the programming slot, and press the start button once.
6) Wait 5sec, and press the Start button once.
7) The door lock should cycle once, confirming the remote was accepted. If the door lock cycle twice or doesn't cycle at all, remote was not accepted. Repeat process.
8) Remove the new key from the programming slot and press any button to test it.
9) your remotes are now programmed, verify your remote start your car.
Smart Proximity Key (Push Button Start)
Method #3: Add a Key Procedure (2min)
1) Place two working key inside the car and the unprogrammed key in the programming slot (look for a pocket either in the center console, glove box or under the cup holder mat)
2) Within 10sec, press the Unlock button on the driver's door for (3) times.
3) Press the Brake pedal once
4) Within 10sec, press the Lock button on the driver's door for (3) times.
5) Press the Brake pedal once
6) Press the start button once.
7) Remove the new key from the programming slot and press any button to test it.
8) your remotes are now programmed, verify your remote start your car.
To get a key cut to your vehicle shop here.
